This topic contains 3 replies, has 3 voices, and was last updated by  Harter 2 years, 5 months ago.

  • Author
    Posts
  • #47033
     uber7mm 
    Participant
    • Silver
    • ★★
    • Posts: 17
    • Comments: 288
    • Overall: 305

    I was tinkering at the workbench yesterday and found that cabinet knobs are the same thread (8×32 tpi) as the case prep tools I own.

    The commercial handles are a bit expensive.

    I hope this helps.

  • #47034
     Goodsteel 
    Keymaster
    • Gold
    • ★★★
    • Posts: 208
    • Comments: 2452
    • Overall: 2660

    Har!!!! Good hack!!!

  • #47035
     uber7mm 
    Participant
    • Silver
    • ★★
    • Posts: 17
    • Comments: 288
    • Overall: 305

    The woodscrew in the kitchen cabinet door to replace of the knob didn’t go over well.  I’d better put the knob back.   LOL

  • #47041
     Harter 
    Participant
    • Gold
    • ★★★
    • Posts: 73
    • Comments: 802
    • Overall: 875

    I have a couple of desk drawers with A-Meric 9mm knobs on them not really the same but it might’ve gone over better in the kitchen .

You must be logged in to reply to this topic.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.