#23916
chutesnreloads
Participant
  • Silver
  • ★★
  • Posts: 4
  • Comments: 161
  • Overall: 165

Amiaji,you could have a PC failure but its just as likely your push thru die is a bit rough or the bullets are too fat from the PC.Do the smash test and check your new bullet diameter 1st and if that looks good try and smooth out that die.I have a bore lapping kit from years ago.Gritted up some bullets with the compounds and slicked that die right up.Some others on here can give other ways of doing it too

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.