#23120
IllinoisCoyoteHunter
Participant
  • Bronze
  • Posts: 7
  • Comments: 74
  • Overall: 81

Micrometers. Gotta have them! At the very least to check your sizing die.

If you buy a mic try to get one that reads to the tenths (ten thousandths). That’s .0001″. If you ever have to lap a sizing die it is good to know exactly how much you are taking off. It helps take out a lot of the guesswork and can make quick (er) work of a time-consuming job (like lapping a sizing die).

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.