#30437
Doc Highwall
Participant
  • Silver
  • ★★
  • Posts: 8
  • Comments: 123
  • Overall: 131

Part 2
This is what the stock looked like being machined, if you look you can see the .375″ end mill in the picture.
This is the stock with the opening for the bedding block complete, ready for the bedding block to be bonded in. As you can see the stock was originally inletted for a right hand action and you can see the cut out for the bolt. I did remove the bonding material where the magazine was. Then I checked the fit for the bedding block making sure there was room for the Devcon 10110 putty.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.