#69334
Jniedbalski
Participant
  • Silver
  • ★★
  • Posts: 24
  • Comments: 209
  • Overall: 233

Have the barrel taken off . Then have your gun Smith take some off the end of the barrel . And re chamber it. Go with a short target chamber with .030 bullet engraved on loading makes for a very accurate rifle. The extractor cuts have to be recut . depending on if the barrel is threaded or pined depends on also if it needs re threaded when shortened. I had my Brno Chinese copy done because it blew out a small hole in the side of the chamber . One of the extractor cuts was to close to the chamber and over time weekend and blew out.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.