#49164
Rattlesnake Charlie
Participant
  • Gold
  • ★★★
  • Posts: 152
  • Comments: 679
  • Overall: 831

I tried double nutting the lock rings, but then I had difficulty getting a wrench on the lower ring to tighten or loosen it.

As for the Hornady rings, they do not allow a hex wrench. And, with the limited clearance on the tool head of Dillon presses, it sometimes gets challenging. I guess I should not complain too much as once the dies get set I should not be adjusting them. OK, then comes the bullet seating die. Seems it always needs adjusting whenever you change bullet designs.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.