#48706
Glenn
Participant
  • Silver
  • ★★
  • Posts: 43
  • Comments: 223
  • Overall: 266

I glued the liner in, waited until morning and cut it off.  Then used a 90deg Brownell’s facing tool to cut it back flush with the end of the barrel, then broke the edge of the muzzle with a brass lap and some 600 grit lapping compound.  A little 44/40 cold blue touched up the muzzle.

Then it was time for a test fire session and it fired and extracted without any problems.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.