#48603
Milkman
Participant
  • Bronze
  • Posts: 4
  • Comments: 24
  • Overall: 28

The .356 molds might be worth a try.  I have found a load that seems to work ( 20 rounds ) and will experiment a little more. I increased the powder charge .2g and the misfeeds seem to have gone away.

I also use the factory crimp die, but with the .358 bullets, even after sizing in a .358 die, the Factory Crimp die will pull the bullets on about 1 out of 15 or 20.  I have never had that problem before.  I am assuming that the bullet is over size and the FCD is sizing it down along with the brass, and then it is a loose fit and comes out when the ram is lowered.  It only seems to happen on those cartridges which are harder to fit into the FCD, which would indicate an overly large bullet.

© 2017 Goodsteel Forum. Designed by Covalent Designs, LLC.